Zebra 01407-000 ユーザーズマニュアル
Programming
Software Command Syntax
Software Command Syntax
50
P1003643-001
TTP 1020™/TTP 1030™ Technical Manual
03/03/2009
Status Reporting Commands
See also
A status enquiry results in response ACK (06h) if all sensors are clear, but NAK (15h) + code if
one or more sensors report fault condition.
one or more sensors report fault condition.
Table 6 • Error codes
A status enquiry command can only return one status code at a time. If there are two or more
simultaneous errors, each error condition should be cleared and the status enquiry repeated in
order to get a complete report of all status codes.
simultaneous errors, each error condition should be cleared and the status enquiry repeated in
order to get a complete report of all status codes.
The host computer cannot be certain that all error conditions have been cleared until an
ACK
is
received.
The possible error conditions are reported in the above order.
ESC ENQ 1
Status enquiry
1B
05
01 hex
027
005
001 decimal
Error code
Meaning
ACK
OK (printer is operable)
NAK 01h
Paper left in presenter module. Attempt to clear the paper path failed.
NAK 02h
Cutter jam
NAK 03h
Out of paper
NAK 04h
Printhead lifted
NAK 05h
Paper-feed error. No paper detected in presenter although 10 cm has
been printed. Paper might be wound around the platen or, in some way,
has been forced above the presenter module.
been printed. Paper might be wound around the platen or, in some way,
has been forced above the presenter module.
NAK 06h
Temperature error. The printhead temperature has exceeded the 80 °C
maximum limit.
maximum limit.
Important •
Errors 2, 5, and 6 are terminal faults that require you to reset the printer before it
will be operable again. The printer automatically recovers from the other error conditions as
soon as the error is corrected.
soon as the error is corrected.