Samsung SSA-S3020 ユーザーズマニュアル

ページ / 80
60_
 
advanced setup
advanced setup
INPUT TIME SCHEDULE SETUP
You can assign a Time Schedule Code to each input to activate the input only during that period.  The default Time 
Schedule Code for every input is “00”, which means no Time Schedule is applied to them.  Changing these settings can 
be very useful when you want to activate PIR sensor during a certain period of time.
Press the 
F
5
 SETUP MENU button.
Use the buttons 
4
 and 
6
 to move to INPUT T/S and press 
ENT
.
Use the numeric buttons to enter 2-digit code and press 
ENT
.
T/S(Time Schedule) CODE : 00~10
EX :  EXIT Button Input T/S Code
DC :  Door Contact Sensor Input T/S Code
I1 :  Aux Input#1 T/S Code
I2 :  Aux Input#2 T/S Code
TP :  Tamper Switch Input T/S Code
If the entry is incorrect, the “INVALID NUMBER” message will appear.
The T/S Code ‘00’ means no Time Schedules are to be applied.
INPUT CUT OFF CHECK SETUP
You can choose whether or not to check the connection cutoff of each input port. The default setting is “00”.  To enable 
the cut off check function, change the setting to “01”. 
 In case of cut off detected at the input while the cut off check enabled, the corresponding output signal is given as per 
“Cut Off Output Setup”. (See Page 46.)
Press the 
F
5
 SETUP MENU button.
Use the buttons 
4
 and 
6
 to move to CUT OFF SET and press 
ENT
.
Use the numeric buttons to enter “00” or “01” for each input.
00 :  The Input Cut Off check function is disabled. 
01 :  The Input Cut Off check function is enabled.
EX :  Whether to use EXIT Button input cut off check.
DC :  Whether to use Door Contact Sensor input cut off check.
I1 :  Whether to use Aux Input #1 input cut off check.
I2 :  Whether to use Aux Input #2 input cut off check.
TP :  Whether to use Tamper Switch input cut off check.
If the entry is incorrect, the “INVALID NUMBER” message will appear.
Before enabling this function, a 2.2K
Ω resistor should be connected between the input wire and the GND.
1.
2.
3.

1.
2.
3.
M
12. CUT OFF SET
E X   D C   I 1   I 2   T P
0 0   0 0   0 0   0 0   0 0
12.CUT OFF SET
E X   D C   I 1   I 2   T P
0 1   0 0   0 0   0 0   0 0
11. INPUT  T/S
E X   D C   I 1   I 2   T P
0 0   0 0   0 0   0 0   0 0
11. INPUT  T/S
E X   D C   I 1   I 2   T P
1 0   0 0   0 2   0 0   0 0