Samsung SCC-B5343P ユーザーズマニュアル

❚

To set the available functions on your camera, adjust eight switches as shown below:

Installation

1

LL

Line lock ON/OFF

2

LSS

Sens-up or Low speed shutter ON/OFF

3

H-REV

Horizontal reverse ON/OFF

4

V-REV

Vertical reverse ON/OFF

5

BLC

Backlight compensation ON/OFF

6

FL

Flickerless ON/OFF

7

D/N

Automatic switching between color and 

black & white ON/OFF

8

AWB

Automatic white balance ON/OFF

1.  Switch 1 (LL): When this switch is set to OFF, the camera operates in the internal 

synchronization mode, while when it is set to 

ON, the camera operates in the line lock mode.  

In the internal synchronization mode, the camera always uses an inside crystal oscillator for 

synchronization. However if multiple cameras are connected to a sequential switcher, picture 

rolling or flickering may occur when switching from one camera to another. In this case, you 

can set this switch to 

ON to solve this problem. 

The line lock mode allows the camera to use the phase of the AC power as the 

synchronization reference. In this mode, you can use the phase control buttons(INC/DEC).

When you are using the DC 12V power, set this switch to 

OFF. The line lock feature will not normally 

operate even when the switch is set to 

ON.

Set the LL switch to 

ON while the AC power is connected. If any picture roll happens, you have 

to adjust the phase using the phase-control buttons. Press the 

INC or DEC button to increase or 

decrease the phase by one degree.

01-B5342_B5343-00648D(03)Eng.ind8   8

2008-08-22   오후 4:49:01