Samsung SCC-B1310P/CDM ユーザーズマニュアル

1. ELC

2. BLC

3. FL(Flickerless)

4. AWB

5

SW1(ELC)
Use this for the manual iris lens. If set to ON, the electronic 

shutter speed varies between 1/60 and 1/120,000 second 

to keep the screen brightness proper. However, you must 

position this switch to OFF if you are using the auto iris 

lens (DC control type). Because, in this mode, the camera 

can show the color rolling effect when operating under the 

mechanical fluorescent lightning. If this happens, apply the 

AC power and set the L/L to "EXT".

SW(BLC)
Use to compensate for a display that is too bright or too 

dark when indoor lighting or windows reflects against the 
subject. Set to ON for these conditions.

SW3(FL)
It is an anti-flicker system that prevents the flickering of the 

image due to mismatch between the vertical sync frequency 

and the on-off frequency of lighting.

It is used when the camera and broadcasting system within 

its own region do not match each other. If set to ON, the 

electronic shutter speed stays at either 1/100sec (NTSC).

If SW1 (ELC) is set to ON, the anti-flicker system 
does not work even if SW3 is positioned to ON.

SW4(AWB)
ON(ATW):  It automatically adjusts the image color 

according to the temperature change of the 

lightning color. Under a very irregular lightning 

condition (such as car headlight), if set to ON, 

it captures a subject normally (white).

OFF(AWC):  It remembers the normal color temp switch 

with the OFF to operate at a certain white 

balance level.

Note that AWB can cause an error in the following 
conditions:

-  If a big subject of a uniform color with a high 

saturation exists in the center of the screen or 
if few part of the image is in white.

-  If lighting is made of special material like 

sodium.

02387A -SCC-B1310-NA-ENG.indd   14

2009-05-27   오후 2:54:50