Samsung SDB-100 ユーザーズマニュアル

✔

Please check whether the installation site can sufficiently support 

the weight of the SDB-100 before installation.

✔

Make sure that the cable is not caught on anything or its insulation

sheath is not removed. 

(Neglecting to do so may cause fire or damage to the product.)

✔

Prevent people from approaching the installation area, where 

objects might fall during installation. Move valuables to a safe

location before installation.

✔

Install the SDB-100 in a cool location, away from direct sunlight. 

It is recommended that the SDB-100 is located in an area not 

subject to direct sunlight during use or storage.

✔

The SDB-100 must be used in an area where temperature and 

humidity are kept within the limits specified below:

- Temperature: -10°C ~ +50°C (14°F~122°F)

- Humidity: Below 90%

➤

Choose an installation site that can sufficiently support a minimum of 

five times the net weight of the equipment to be installed (approx. 500g).

1. Unscrew the CASE SCREW and then disassemble the TOPCASE.

2. Connect RJ45 CONNECTOR with the Camera, and connect the other 

RJ45 CONNECTOR with the Monitor.

System connection is refer to system connection diagram.

3. If you want to use Aux Control. Connect the Aux Control +port  and - port 

with other device that use Aux Control output (DC17V, 300mA).

4. After the cable connection is completed, you must arrange the cables so that 

won’t get damaged.

5. Screw BODY of the SDB-100 and the satisfied place with the INNER SCREW 

(2 point).

6. After, close the TOPCASE, screw TOPCASE and BODY with the CASE 

SCREW.

RJ45  CONNECTOR

INNER SCREW

BODY

CASE SCREW

AUX CONTROL

+

TOPCASE

M

❖

00333A SDB-100-GB  2003.11.25  10:44 AM  Page 6