ICOM IC-U82 ユーザーズマニュアル
41
10
PAGER/CODE SQUELCH
10
• PERSONAL CALLS
This display appears when you are called with your ID code
and the calling station’s ID code is 123.
This display appears when you are called with your ID code
and the calling station’s ID code is 123.
• GROUP CALLS
This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.
This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.
• ERROR INFORMATION
When the transceiver receives an incomplete code, “E” and
previously received code appear.
When the transceiver receives an incomplete code, “E” and
previously received code appear.
■
Code squelch
When using code squelch you will only receive calls from sta-
tions which know your ID or group code. A 3-digit code is sent
each time [PTT] is pushed in order to open the receiving sta-
tion’s code squelch prior to voice transmission.
tions which know your ID or group code. A 3-digit code is sent
each time [PTT] is pushed in order to open the receiving sta-
tion’s code squelch prior to voice transmission.
q
Set the operating frequency.
• Set the volume and squelch to the desired level as in normal op-
eration.
w
Push [A•
FUNC
], then push [0•
OPT
].
• Rotate [VOL] to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-
pears.
e
Select the desired transmit code channel:
➥
Push and hold [0•
OPT
] for 1 sec. to enter code selection
mode.
➥
Rotate [VOL] to select the desired code channel.
➥
Push [
✱
•
ENT
] to exit code selection mode and return
to previous mode.
• 100 MHz digit shows “C.”
r
Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
transmit; release [PTT] to receive).
t
To cancel the code squelch, push [A•
FUNC
] and [0•
OPT
],
then rotate [VOL] to select “dtm.OF.”
• 100 MHz digit shows “1” for IC-V82 or “4” for IC-U82 when the
function is cancelled.
Previously received code.
Code channel
“CP” and “ ” blink.
During channel number indication (described on page 16)
To use these functions in channel number indication, the
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.
To use these functions in channel number indication, the
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.