Omron C200HW-CLK21 ユーザーズマニュアル
299
Status Area and Troubleshooting
Section 9-2
9-2-2
C200HX/HG/HE Controller Link Units
The status of the Unit and Network is indicated in the following manner in the
PLC.
PLC.
Status Area
Duplicate Operating Levels/Refresh Error: AR 00
Routing Table Error/Unit Restart Bits: AR 01
Network Participation Status: AR 08, AR 09, AR 12, AR 13
Communications Controller Hardware Error, EEPROM Error: AR 11, AR 15
Service Time: AR 16, AR 17
Operating Level Connection Status, Inconsistent Network Parameters: AR 24
A bit will be turned ON (1) the
next cycle when
1) The same operating level is
next cycle when
1) The same operating level is
set more than once or
2) A refresh error occurs
between the Controller LInk
Unit and the PLC's CPU Unit.
Unit and the PLC's CPU Unit.
Operating level 1
Operating level 0
Operating level 0
Operating level 1
Operating level 0
Operating level 0
1: Routing table error
Resets the Controller Link Unit.
Turn ON (1) and then OFF (0)
to reset Unit.
Turn ON (1) and then OFF (0)
to reset Unit.
Operating level 1
Operating level 0
Operating level 0
AR 08
AR 09
AR 08
AR 09
Operating level 1
AR 12
AR 13
AR 12
AR 13
The numbers in the squares indicate node addresses.
The corresponding node participation status is as follows:
0: Not part of network
1: Part of network
The corresponding node participation status is as follows:
0: Not part of network
1: Part of network
Operating level 0
AR 11
AR 11
Operating level 1
AR 15
AR 15
1: Communications controller hardware error
1: EEPROM error
Operating level 0
AR 16
AR 16
Operating level 1
AR 17
AR 17
The service time for each PLC cycle is calculated by the PLC
and displayed in 0.1-ms units in 4-digit BCD.
and displayed in 0.1-ms units in 4-digit BCD.
Operating level 1
Operating level 0
1: Network parameters do not match
1: Connecting to the operating level
Operating level 1
Operating level 0
Operating level 0