Canon ir2016, ir2020 マニュアル

2-6

17) Put back the parts that have been removed.

- RAM cover

- the connector of the IP-modem cable (if a Super G3 Fax Board-T1 is mounted)

- rear left cover

- rear cover

18) Connect the power plug, and turn on the main power switch.

When you have installed the kit, go through the following to make sure that it is properly recognized:

1) Start service mode.

User Mode key > 2 > 8 > Use Mode key

 In response, [#SSSW] appears.

2) Press [

] 5 times. When [REPORT] has appeared, press [OK].

3) Press [

] once. When [REPORT OUTPUT] has appeared, press [OK].

4) Press [

] 5 times. When [SPEC LIST] has appeared, press [OK].

5) See that a SPEC REPORT is printed out. Check to be sure that 'PCL' is 'ON'.