Clarity c4210 ユーザーズマニュアル

24

25

1.    Press the TALK button (TALK button will  
 

illuminate GREEN) and dial the number you  

 

wish to call. 

2.    To end the call press the TALK button or place  
 

the handset in the base.

 

Or

1.    Press the keys of the numbers needed to dial.  
 

The LCD will display PREDIAL and the 

      keys pressed.
2.    Press the TALK button. Handset will go off- 
 

hook and dial the displayed numbers.

If the handset is out of the cradle, press the  
TALK button. 

If the handset is in the cradle with Auto-Connect 
Mode ON, lift the handset. The handset will be in 
receiver mode.

If the handset is in the cradle with AutoConnect 
mode OFF, lift the handset. The handset will be in 
standby mode. Press TALK button to receive  
the call.

Refer to BOOST Clarity Power and Volume Control 
for information on adjusting volume controls on  
Page 19.

The last number dialed (up to 32 digits) is stored in 
the redial memory until another number is dialed.

To use this feature:

1.    Press the TALK button.
2.    When you hear the dial tone, press the  
 

RD/P button.

3.   The phone will automatically dial for you.

Programming in a pause will cause the phone to wait 
four (4) seconds before dialing additional numbers. 
This feature may be used when it is necessary to dial 
an access code (9, for example) and wait for a sec-
ond dial tone before you can dial an outside number. 
Press the RD/P button at the required point during 
the memory storage process to program a pause. 

If you have rotary (pulse) dial service, you can change 
from pulse to touch tone (tone) during a call. 

1.    Make phone call and wait until it  
 

is connected. 

2.    Press the * key.  Keys pressed after this are  

 

 

sent as tone signals.

3.    The phone will automatically reset to rotary  

 

 

(pulse) service after the call ends.

The key pad will light for fifteen (15) seconds after 
removing the handset from the base. To reactivate 
the feature while in standby, press the TALK or the 
MEM button. To activate while the phone is in use, 
press any key.

To send a page signal from the base to the handset, 
press the PAGE button located on the base of  
the telephone. A series of rings will sound from  
the handset.

To locate the handset if it is away from the base, 
press and hold the PAGE button for approximately 
five (5) seconds.  A series of rings will sound.  Return 
the handset to the base or press any  
button to cancel the page.