Clarity c4210 ユーザーズマニュアル

12

13

CAUTION: Disconnect the telephone line cord 
before connecting or disconnecting the battery 
backup in the wall mount bracket.

1.  Plug one end of the supplied modular tele- 

 

 

phone line cord into the jack marked TEL  

 

located on the back of the telephone base  

 

as shown in the diagram.

2.  Plug the modular telephone line cord’s other  
 

end into a modular phone jack.

3.  Insert the supplied AC Adapter’s plug into the  
 

jack marked 9V DC 400mA located on the  

 

back of the telephone base.

4.  Plug the adapter into a standard 120V AC  
 

power (electrical) outlet. 

5.  Align the mounting bracket on the back of  

 

 

the base so that the black rubber feet are  

 

towards the bottom of the phone. Insert the  

 

bracket’s tabs into the slots and secure the  

 

bracket by sliding it upward.

6.  Lift the base’s antenna to a vertical position.
7.  Set the TONE/PULSE switch located on the  
 

back of the base to correct dialing mode.  

 

Please check with your local Phone Company  

 

if uncertain of the type of service. 

8.  Place handset in the cradle to begin  
 

initial charging.

CAUTION: Disconnect the telephone line cord 
before connecting or disconnecting the battery 
backup in the wall mount bracket.

The base unit may be mounted on a standard  
wall plate.

1.  Plug one end of the supplied short modular  

 

 

telephone line cord into the TEL jack located  

 

 

on the back of the base of the phone.

2.  Insert the plug of the AC adapter into the  

 

 

jack marked DC 9V 400mA located on the  

 

 

back of the telephone base.

3.  Align the mounting bracket on the back of  

 

 

the base so that the black rubber feet are  

 

 

towards the bottom of the phone. Insert the  

 

 

bracket’s tabs into the slots and secure the 

 

 

bracket by sliding it upward.

4.  Plug the short modular telephone line cord  

 

 

into the wall plate jack, then align the mounting   

 

bracket’s keyhole slots with the wall plate  

 

 

studs and slide the base of the phone down- 

 

 

ward to secure it on the wall. 

5.  Plug the adapter into a standard AC power  

 

 

(electrical) outlet. 

6.  Press and lift out the handset holder tab, turn    
 

it around so the narrow tab end extends out 

 

 

and slide back into its slot. This will hold the 

 

 

handset in the cradle when the phone is  

 

 

 

wall mounted.

7.  Lift the base’s antenna to a vertical position.
8.  Set the Tone/Pulse switch located on the  

 

 

end of the base to correct dialing mode.   

 

 

Please check with your local Phone Company 

 

if uncertain of the type of service. 

9.   Place handset in the cradle to begin initial  

 

 

charging. Remember, you must charge the 

 

phone for at least 12 hours before you use  

 

 

the phone for the first time.

Note: Remember, you must charge the phone for  
at least 12 hours before you use the phone for the 
first time.