Canon ir2016, ir2020 マニュアル
Chapter 3
3-5
F-3-26
3.3.1.7 Removing the Process Tray Unit
0010-6538
1) Remove the stepped screw [1] (rear side) and RS tightening screw [2]
(front side), and then remove the stay [3] and process tray [4] (right side).
F-3-27
2) Remove the stepped screw [5] (front side) and RS tightening screw [6]
(rear side), and then remove the process tray [7] (left side).
F-3-28
3.3.1.8 Removing the Feed Motor
0010-6539
1) Remove the harness [2] from the guide [1].
2) Remove the two binding screws (M4 x 4) [3], and then remove the feed
motor [4].
F-3-29
3.3.2 Stapler
3.3.2.1 Removing the Inner Cover of the Finisher
0011-1395
1) Open the front cover of the finisher.
2) Remove the four RS tightening screws (M3 x 8) [1], and then detach the
inner cover [2] of the finisher.
F-3-30
3.3.2.2 Removing the Stapler
0011-1396
1) Disconnect the two connectors [1], remove the screw [2], and then remove
the stapler.
F-3-31
3.3.3 Offset Motor
3.3.3.1 Removing the Top Cover
0010-6552
1) Remove the three RS tightening screws (M3 x 8) [1], and then detach the
top cover [2].
[1]
[2]
[3]
[2]
[4]
[3]
[1]
[7]
[5]
[6]
[3]
[2]
[1]
[4]
[1]
[2]
[1]
[3]
[2]