Apple emac ati usb2 2005 サービスマニュアル
20 -
eMac ATI Graphics/USB 2.0/2005 Troubleshooting
General Information
Display/Analog Voltage Setting and LHR Module Instructions
The display/analog (service module) contains a non-switching power supply which is preset at a 220V
configuration. The voltage selection is manually set by way of a voltage jumper. This means if you are
replacing the display/analog assembly and you will be operating the computer in a 110V environment, you
will have to install the voltage jumper on the module.
The following instructions explain how to configure the voltage and LHR jumpers on the digital/analog
assembly.
Note:
The LHR coil (a line conditioning module) is required in some international countries.
Refer to Table 1 for jumper settings and the following photos for jumper and LHR locations.
Tools
This procedure requires the following tools:
• needlenose pliers to remove/attach the voltage jumper
• phillips #2 screwdriver if attaching the LHR module
Table 1: Jumper Settings
Voltage
Environment
Voltage Jumper
Setting
LHR Jumper
Setting
110 V
Jumper is on
Jumper is on
220 V
no LHR module
no LHR module
Jumper is off
Jumper is on
220 V
with LHR module
with LHR module
Jumper is off
Jumper is off, LHR
module installed
module installed