Acomdata m-hdxxxse5-72-pci-v1e ユーザーズマニュアル
– 29 –
the end of each screw just far enough to hold the nut
to the screw. Do not tighten the nuts.
to the screw. Do not tighten the nuts.
2. With both screws and nuts in place, push down on
each screw head to make sure the screws extend
through the holes as far as they will go.
through the holes as far as they will go.
3. Attach the stand to the Drive case by sliding the
nuts through the groove in the Drive case, entering
from the backside of the case. You cannot slide the
stand in from the front of the case. The stand is sym-
metrical so it does not matter which end you insert
first. Once the
nuts are in the
groove, posi-
tion the stand
so that it is
centered with
the Drive case.
from the backside of the case. You cannot slide the
stand in from the front of the case. The stand is sym-
metrical so it does not matter which end you insert
first. Once the
nuts are in the
groove, posi-
tion the stand
so that it is
centered with
the Drive case.
3. While holding the stand in place with one hand, use
a screwdriver with the proper type and size head
to tighten the screws. Make sure the stand is firmly
secured to the Drive case.
to tighten the screws. Make sure the stand is firmly
secured to the Drive case.