AMX design xpress home theater v1.3 ユーザーガイド

 

(Dynalite): K:P:[14]:12:25 indicates area #14, go to preset scene #12 at 25-second 

fade rate.

 

The Clear button clears the Preset Name, Address and Button Number information for a 

selected preset.

Select a Preset and click the up/down arrows (to the right of the Lighting Presets table) to rearrange 

the order of the list.

The ALD-D48 is not controlled by Send Commands, so each button on the touch panel or keypad 

corresponds to a specific dimmer. 

For instructions on developing NetLinx code to program scenes for the D48, refer to Tech Note # 

TN 543, available via www.amx.com (Dealers > Tech Center > Tech Notes).

For detailed configuration information on the ALD-D48, refer to the ALD-D48 Network Lighting 

Solution Instruction Manual, also available via www.amx.com (Dealers > Tech Center > Tech Docs 

> Instruction Manuals).

On Radia lighting systems, channels 1-128 represent Radia lighting presets 1-128. If a channel is 

on, then the corresponding preset is on. However, on startup NetLinx resets all channels to 0 (OFF). 

Radia does not report the status of its channels when the master comes up, and consequently the 

software believes the state of all of the presets is OFF. Therefore, until a preset changes in the 

system, the channel states are not reported.

It is important to have the Lighting Preset information prior to finishing the project.

 

Enter a new Preset Name, Address and Button Number, and click the Add button to add a 

new preset to the bottom of the list.

 

Select a Preset in the list and click the Delete button to delete that preset from the list.

 

The Insert button inserts a new preset at the order number of the currently selected 

preset.

 

Click the Apply button after editing a preset to apply the changes.

 

The Clear button clears the Preset Name, Address and Button Number information for a 

selected preset.