Aopen crw2440 ユーザーズマニュアル
Hardware Installation
-- E-10 --
1. Remove the housing or casing of your computer. Be careful of any sharp edges,
which might be hidden inside your computer.
2. If there is not any other CD-ROM drive installed in your system. We recommend
installing the CD-R/RW in the Secondary IDE port. It is unnecessary to adjust any
other jumpers on the CD-R/RW. Proceed to step 4 for further installation.
other jumpers on the CD-R/RW. Proceed to step 4 for further installation.
3. If a CD-ROM drive is already installed in your system.
We recommend that you install the CD-ROM on the Secondary IDE
channel as the master device (MA), and the CD-R/RW on the Secondary
IDE channel as the slave device (SL). Please follow the steps below to
fulfill this arrangement.
channel as the master device (MA), and the CD-R/RW on the Secondary
IDE channel as the slave device (SL). Please follow the steps below to
fulfill this arrangement.
Ÿ First make sure that your Secondary IDE cable has two ports available for two
Ÿ IDE devices. If not, ask your main board vendor or purchase one from computer
Ÿ IDE devices. If not, ask your main board vendor or purchase one from computer
hardware stores.
Ÿ If the CD-ROM drive was installed in the Primary IDE channel, disconnect it
from the Primary IDE cable.
Ÿ Adjust the Device Configuration Jumper of the CD-ROM drive to “Master” (MA)
position.
Ÿ Adjust the Device Configuration Jumper of the CD- R/RW to “Slave” (SL)
position.