ASUS mypal a600 ユーザーズマニュアル
Avolites Pearl 2000 Operators Manual - page
31
P2000MAN.DOC 19/10/99 17:59
•
Press CLEAR to empty the Programmer (See Section 1.5 The
Programmer for more details).
•
Make sure all the Master Faders are at full and all the Playback Faders
are at zero.
•
Turn the Roller to the Facet you wish to record onto.
•
Select Roller Page one, two or three. The Roller Page Buttons are
located to the left of the Roller.
located to the left of the Roller.
There is no need to press ENTER.
•
Press the blue CHASE button on the Program Select bank.
Its LED will light
up and you can see which Playback Faders are free because their SWOP button LED’s
will flash.
will flash.
•
Press the flashing SWOP button of the Playback Channel you want to
record the Chase onto.
record the Chase onto.
All the other Playback Fader LED’s will stop flashing.
•
Create the scene you wish to record as Step 1 of your Chase by
selecting the appropriate Pages of Fixtures and raising Preset Faders,
and connecting the Wheels to different Attributes to create LTP looks.
Alternatively use a Preset Focus to create a look. See Chapter 8 Preset
Focuses.
and connecting the Wheels to different Attributes to create LTP looks.
Alternatively use a Preset Focus to create a look. See Chapter 8 Preset
Focuses.
•
Press the flashing SWOP button of your Playback Channel to record the
step.
step.
The prompt line on the Screen tells you your next step number.
•
Repeat the previous two directions for as many steps as you wish to
record.
There is no limit to the number of Chase steps provided that there is enough
memory left in the desk
•
Press the CHASE button again.
The Chase is now recorded. The LED on the
Playback SWOP button will light to indicate it has something recorded on it and the LED
on the CHASE button goes out.
on the CHASE button goes out.
•
Press CLEAR to release Channels from the Programmer.
⇒
If the Playback Fader is not at zero, you must lower it to zero before you
raise it again to recall the Memory.
It is very important to get into the habit of pressing CLEAR, to ensure
that you do not end up recording Channels into your next Memory or
Chase that are not intended.
that you do not end up recording Channels into your next Memory or
Chase that are not intended.
3.7.1 Connecting a Chase
You can alter aspects of the Chase by CONNECTING it.
•
Turn the Roller to select the Roller Facet of the Chase you wish to
Connect.
•
Raise the Chase Playback Fader above the Trigger Point
. This is the point
at which the Chase will start to run
.
•
Press the blue CONNECT button in the Sequence Control area
. The LED’s
of all the Chases on this page of the Roller will flash
.
•
Press the SWOP button of the Chase you want to Connect.
The Chase
LED’s stop flashing.
We say the Chase is now CONNECTED.