ASUS v2-p5g45 ユーザーズマニュアル

2-20

Chapter 2: Basic installation 

7.  Connect the other end of the IDE ribbon cable to the secondary IDE 

connector (labeled SEC_IDE) on the motherboard. See page 4-7 for the 

location of this connector.

8.  Remove the dummy drive slot cover from the front panel.
9.  Replace the front panel. 

To install a Serial ATA hard disk drive:

1.  Carefully place the hard disk into the the lowest 3.5-inch drive slot (without 

the metal plate cover).

2.  Fasten the screws to secure the hard disk to the drive slot.

the lowest 3.5-inch 

drive slot without 

the metal plate 

cover

3.  Connect one end of the Serial ATA cable to the SATA connector at the back 

of the drive, then connect the other end to a Serial ATA connector on the 

motherboard. See page 4-6 for the location of the Serial ATA connectors.

If you do not need to install the optional card reader into your system, you can 

install the HDD in the one of the 3.5-inch external bay (with the metal plate 

cover).