HP laserjet 3390, 3392 all-in-one サービスマニュアル
Fuser
Several parts must be removed before you can remove the fuser. Removal procedures for the following
parts are included in this section about removing the fuser:
parts are included in this section about removing the fuser:
●
Fan
●
Duplex-drive gears
●
Duplex solenoid
Fan
1.
Remove the following components.
●
Right cover. See
●
Left cover. See
.
●
Rear cover. See
.
●
Top cover. See
.
●
Convenience-stapler power supply. See
.
●
Convenience-stapler power supply bracket. See
2.
Disconnect one connector (callout 1) at the ECU and feed the wire-harness through the hole in the
chassis (behind the power-switch PCA).
chassis (behind the power-switch PCA).
NOTE
It might be easier to remove the wire-harness if you remove the power-switch PCA
.
1
Figure 5-54
Remove the fan (1 of 2)
152
Chapter 5 Removal and replacement
ENWW