HP lh 3r ユーザーズマニュアル
Chapter 2
Overview
6
Terms used in this document are defined in the table below.
Term
Definition
Bar nut
Short, threaded bar used behind slide mounting flanges.
Used in place of individual nuts to mate with slide
mounting screws.
Used in place of individual nuts to mate with slide
mounting screws.
Rack nut
Single nut designed to clip behind the rack column and
accept a screw through the hole in the column.
accept a screw through the hole in the column.
Slide
Extendible side bracket which is attached to the rack
chassis columns on which the NetServer is mounted.
Consists of stationary component, and an extendible
member (see Figure 3-3). Allows access to the NetServer
after it is installed in the rack chassis.
chassis columns on which the NetServer is mounted.
Consists of stationary component, and an extendible
member (see Figure 3-3). Allows access to the NetServer
after it is installed in the rack chassis.
Slide mounting flange
Mounting flange located at either end of the slide (see
Figure 3-3).
Figure 3-3).
Rack (rack chassis,
rack enclosure)
rack enclosure)
The equipment enclosure in which the NetServer will be
installed.
installed.
Recessed mounting
brackets
brackets
Two brackets (one tall, one short) that attach to the front of
the NetServer and the front rack columns to hold the
NetServer in the closed position.
the NetServer and the front rack columns to hold the
NetServer in the closed position.
EIA unit
Industry standard measurement (1.75 inches / 44.45 mm),
consisting of four vertical mounting holes in a rack
column.
consisting of four vertical mounting holes in a rack
column.