HP pe4240n ユーザーズマニュアル

    Set Up 

 

Use standard 75-ohm coaxial cable to connect a cable TV set-top-box signal cable to the TV. Use 
shielded coaxial cable to reduce radio frequency (RF) interference. To make this connection: 

1 Turn off the TV and the cable TV set-top-box. 
2 Connect one end of a coaxial cable to the cable TV set-top-box output connector, and the other end 

of the cable to the TV antenna cable in connector on the back of the TV. 

3 Turn on the TV and the cable TV set-top-box. 
4 Select TV (the channel number) as the input source for the main TV picture by using the front panel 

buttons or the TV remote control. Refer to “Selecting the input source” on page 26. 

5 Perform the Automatic Channel Scan (auto scan) procedure; refer to “Run auto scan” on page 33. 

This procedure includes the following tasks: 

• 

Selects Antenna or Cable for Signal Type in the TV Setup menu of the OSD menus. 

• 

Scans and identifies the available channels. 

 

6 To set up the TV remote control to operate the set-top-box, refer to “Programming the remote control 

for component control” on page 53. 

 

To connect the signal cable from a digital TV (DTV) receiver to the TV, use the component video input 
connectors (YPbPr-1) or the DVI-D connector on the back of the TV. Refer to “Connecting a Component 
Source” on page 20, or “Connecting a PC or Other Equipment to the TV Using the VGA or DVI 
Connector” on page 17.