HP pe4240n ユーザーズマニュアル

Using the TV    

 

 

The steps in this section describe how to: 

• 

Set up the TV channels, including Automatic Scan of channels, adding or deleting a channel, and 
setting up favorite channels: see page 33. 

• 

Fine tuning a channel: see page 37. 

• 

Mapping channels: see page 38. 

• 

Adjusting the picture: see page 40. 

• 

Setting up the Picture-in-Picture/Picture-on-Picture display: see page 41. 

• 

Adjusting the sound, including selecting the speaker source and selecting the SAP channel: see 
page 42. 

• 

Washing the screen to reduce the effects of image retention on the plasma screen: see page 44. 

• 

Selecting Auto Off mode to turn off the TV when the input signal is lost (as when the TV is 
connected as a monitor to a PC): see page 45. 

• 

Setting parental guidance by using the V Chip setup: see page 46. 

• 

Using closed caption: see page 50. 

• 

Setting up the VGA connector for use: see page 51. 

• 

Selecting the color system: see page 51. 

 

This section has three procedures: 

• 

Run auto scan. The first time you connect an antenna or cable TV, perform the Auto Scan 
procedure to obtain the available channels. 

• 

Add or delete a channel. After channels are identified using auto scan, use this procedure to 
modify the channel list. 

• 

Set up favorite channel. Defines the channel to use for the A and for the B buttons on the 
remote control. 

 

1 Make sure TV is the input signal for the main picture. Refer to “Selecting the input source” on 

page 26. 

2 Display the OSD menus. Refer to “Using the On Screen Display (OSD) Controls” on page 28 for 

steps to open and use the menus using the front panel buttons (or the remote control buttons).