Canon fax-jx200 ユーザーズマニュアル
65
Troubleshooting
SET DOCUMENT IN CORRECT POSITION
TX/RX CANCELLED
TX/RX NO. nnnn
!!CHECK!! nnnn
Cause
Action
The document cannot be correctly
detected or the document is too small.
detected or the document is too small.
Make sure the document meets the requirements and is correctly loaded. If
necessary, reload the document and press [Start/Copy]. See “Document
Requirements” on page 15 and “Loading Documents and Paper” on page 16.
necessary, reload the document and press [Start/Copy]. See “Document
Requirements” on page 15 and “Loading Documents and Paper” on page 16.
Cause
Action
You pressed [Stop] to cancel the
transmission.
transmission.
If required, try sending again.
Cause
Action
When the fax sends or receives a
document, it assigns it a unique
identification number (nnnn).
document, it assigns it a unique
identification number (nnnn).
Write the number down if you will need it later.
Cause
Action
An error requiring servicing might have
occurred.
occurred.
Turn OFF the machine, and unplug the power cord of the machine from the
power supply. After a while, plug the power cord of the machine back in and turn
ON the machine. If the same error occurs, contact a Canon service
representative.
power supply. After a while, plug the power cord of the machine back in and turn
ON the machine. If the same error occurs, contact a Canon service
representative.