Canon imageclass mf6560 ユーザーズマニュアル
1
2
3
4
5
6
7
8
Back
7-12
Q
Is the correct size of paper loaded in the
machine?
machine?
A
Make sure you load paper that meets the
requirements for use. (See Chapter 3, “Print
Media,” in the Basic Guide.)
requirements for use. (See Chapter 3, “Print
Media,” in the Basic Guide.)
A
Change <REG. PAPER SIZE> in <COMMON
SETTINGS>. (See Chapter 13, “Machine Settings,”
in the Basic Guide.)
SETTINGS>. (See Chapter 13, “Machine Settings,”
in the Basic Guide.)
Received faxes print blotched or unevenly.
Q
Are the telephone lines in poor condition, or do
you have a bad connection?
you have a bad connection?
A
Error Correction Mode (ECM) should eliminate
such problems. However, if the telephone lines are
in poor condition, you may have to try again.
such problems. However, if the telephone lines are
in poor condition, you may have to try again.
Q
Is the sender’s machine functioning properly?
A
Ask the sender to check that the scanning
components of the machine are clean.
components of the machine are clean.
Q
Is the toner low or unevenly distributed?
A
Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge.
(See Chapter 11, “Maintenance,” in the Basic
Guide.)
the problem persists, replace the toner cartridge.
(See Chapter 11, “Maintenance,” in the Basic
Guide.)
Cannot receive using Error Correction Mode (ECM).
Q
Does the sender’s machine support ECM?
A
If the sender’s machine does not support ECM, the
document is received in normal mode without error
checking.
document is received in normal mode without error
checking.
Receiving of documents is too slow.
Q
Is ECM (Error Correction Mode) set to <ON>?
A
Because ECM corrects errors during a
transmission, any problems on the line can mean
that the transmission will take extra time. Set ECM
to <OFF>.
transmission, any problems on the line can mean
that the transmission will take extra time. Set ECM
to <OFF>.