Canon imageclass mf6560 ユーザーズマニュアル

3-10

– In the following operations in this section, the machine’s MAC 

address is necessary. To check the MAC address from the machine’s 
operation panel, print a USER’S DATA LIST. (See Chapter 13, 
“Machine Settings,” in the Basic Guide.)

– If you are using ARP/PING commands, the following steps directly 

allocate the IP address to the machine. For this machine, in addition 
to direct allocation of the IP address to the machine, you can use 
DHCP, BOOTP, or RARP to specify the IP address. When the 
machine is started or reset, it checks whether DHCP, BOOTP, or 
RARP is being used, and then allocates the IP address using the first 
available setting method. Because the machine’s IP address is 
automatically allocated at this time, it is not necessary for you to 
perform the following operations in this section. However if you are 
reallocating the IP address, or if DHCP, BOOTP, or RARP cannot be 
used, perform the following operations.

– You can maintain security by setting a range of IP addresses of 

computers that are allowed to obtain access to the machine.
Once you set the range of IP addresses of computers on which items 
for the machine can be set or browsed, it is not possible to use the 
Remote UI on computers whose IP addresses are not allowed; a 
utility on the computers cannot be used to set or browse detailed 
information concerning the machine.
Once you set the range of IP addresses of computers from which 
data (print/fax job) can be sent to the machine, the machine rejects 
data sent from computers whose IP addresses are not allowed. For 
instructions on how to specify the IP address range, see “TCP/IP 
Settings,” on p. 3-16.

■