Canon pixma mp130 取り付け手順
1
Unpack and setup the machine.
1
Carefully remove all items from the box.
2
Remove the protective material.
3
Place the machine on a flat surface.
4
Remove all shipping tape and the protective sheet.
5
Lift the Scan Unit (1) until it locks into place, and remove the packing material
(2) from the Print Head Holder.
(2) from the Print Head Holder.
• Be sure to hold the machine by the side. Do not lift the machine by grasping the Paper Support Extension
or the Operation Panel.
X Check the contents.
• A printer cable is not included. You must purchase a USB cable (less than 10 ft./3 m) to connect your
machine to a computer.
• Please note that the items included with your machine may vary depending on the country of purchase.
2
Connect the power cord.
2
If the message <PUT IN CARTRIDGE> appears, go to Step 3, “Install the print
head.”
head.”
3
Install the print head.
1
Lift the Scan Unit until it locks into place.
2
Open the Paper Output Tray (1).
4
Install the ink tanks.
1
Remove the orange protective
cap.
cap.
2
Insert the ink tanks.
• Insert the black ink tank into the right slot, and the color ink tank into the left slot.
IMPORTANT
• For correct printer operation, make sure ink tanks are secure in slots.
3
Close the Inner Cover (1) and the Scan
Unit (2).
Unit (2).
4
If the LCD displays messages asking if
you replaced the ink tanks, press [
you replaced the ink tanks, press [
]
repeatedly to complete the installation.
5
Load the paper.
1
Open the Paper Support (1) and pull up the Paper Support Extension (2) until
it stops.
it stops.
• If you are loading the legal-size paper, set the Attachment (3) to the Paper Support.
2
Load the paper with the print side face up.
• Ensure the paper stack does not exceed Paper Limit Mark.
3
Pinch and adjust the Paper Guide to the width of the stack.
Setup is complete.
If you are connecting the machine to a computer for use, see the reverse side for instructions on
installing the software.
installing the software.
• Machine
• Power cord
• Print head
• Ink tanks
BCI-24 Black
BCI-24 Color
BCI-24 Color
• Paper Support Attachment
• Safety Instructions
• Easy Setup Instructions
• Quick Start Guide
• Setup CD-ROM
The Setup CD-ROM contains the MP Drivers, as well as the electronic manuals User’s Guide, Software
Guide and Photo Application Guide. Please read these guides.
Guide and Photo Application Guide. Please read these guides.
1
Connect the power cord.
(1)
(2)
(1)
(2)
PLEASE WAIT
3
Open the Inner Cover (2).
• The Print Head Holder moves to the center.
Install the print head here (3).
4
Raise the Lock Lever.
5
Remove the protective cap.
6
Insert the print head.
• Do not press it down.
7
Lower the Lock Lever until it locks
into place.
into place.
(3)
(1)
(2)
Do not touch!
Do not touch!
(2)
(1)
(2)
(1)
(3)
Start Here
Easy Setup Instructions
Canon and BCI are registered trademarks and PIXMA is a trademark of Canon Inc.
All other products and brand names are registered trademarks or trademarks of their respective owners.
Specifications subject to change without notice.
All other products and brand names are registered trademarks or trademarks of their respective owners.
Specifications subject to change without notice.
HT7-0095-000-V.1.0
xx2004A
© CANON INC. 2004
PRINTED IN CHINA