Canon FAX-JX210 ユーザーズマニュアル
32
Sending Faxes
Sequential Broadcasting
Sending a Document to More Than One Location
Sequential broadcasting sends one document to more than one location.
You can send to a total of 70 locations as follows:
You can send to a total of 70 locations as follows:
You can enter the one-touch speed dialing and coded speed dialing locations in any order. You
simply press the one-touch speed dialing button, or press [Coded] or [Directory] followed by the
two-digit code.
You can also include one location using regular dialing. Remember that when using regular
dialing, you must press [Start/Copy] after entering the number.
simply press the one-touch speed dialing button, or press [Coded] or [Directory] followed by the
two-digit code.
You can also include one location using regular dialing. Remember that when using regular
dialing, you must press [Start/Copy] after entering the number.
1
Load the document face up into the ADF.
See “Loading Documents and Paper” on page 22.
You can set the scanning resolution and contrast (see page 25).
You can set the scanning resolution and contrast (see page 25).
2
Dial the receiving party’s fax numbers as you need.
You can also press [Redial] to redial the last number dialed with the numeric buttons.
3
Press [Start/Copy].
z
The fax reads the document into memory and begins sending.
z
To cancel a transmission, press [Stop/Reset] during dialing or transmission. All
transmissions in the sequence are canceled.
transmissions in the sequence are canceled.
z
One-touch speed dialing
z
Coded speed dialing
z
Regular dialing (Numeric buttons dialing)
= 9 locations
= 60 locations
= 1 location
= 60 locations
= 1 location
Note
z
You must press each button within 10 seconds of the preceding one. The fax begins the
operation approximately 10 seconds after you press the last button.
z
The regular dialing number must be entered last.
TEL=
3456xxxx