Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Unpack the Router
M40 Internet Router Hardware Guide
92
Figure 21: Place a Board Component into an Electrostatic Bag
Unpack the Router
The router is shipped in a wooden crate and bolted to the pallet that forms the bottom of the
crate. The crate also contains an accessory box, the handle used during manual router
installation, and the M40 Internet Router Installation Quick Start poster.
crate. The crate also contains an accessory box, the handle used during manual router
installation, and the M40 Internet Router Installation Quick Start poster.
To unpack the system, follow these steps:
1.
Move the shipping crate to a staging area as close to the installation site as possible, but
where you have enough room to remove the system components. While the chassis is
bolted to the pallet, you can use a forklift to move it.
where you have enough room to remove the system components. While the chassis is
bolted to the pallet, you can use a forklift to move it.
2.
Position the crate so that the arrows are pointing up.
3.
Open the top flaps on the crate.
4.
Remove the accessory box (see Figure 22).
5.
Open the accessory box and verify the contents against the parts inventory on the label
attached to the box.
attached to the box.
6.
Lift the crate off the pallet.
CAUTION
ELECTROSTATIC
SENSITIVE
DEVICES
DO NOT OPEN OR HANDLE
EXCEPT AT A
STATIC-FREE WORKSTATION
1051
The router is maximally protected inside the shipping
crate. Do not unpack it until you are ready to begin
installation.
crate. Do not unpack it until you are ready to begin
installation.