Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Maintain and Replace Cables and Connectors
Replace PIC Cables
183
Replace PIC Cables
Removing and installing PIC cables does not affect router function, except that the PIC does
not receive or transmit data while the cable is disconnected. To replace a PIC cable, perform
the following procedures:
not receive or transmit data while the cable is disconnected. To replace a PIC cable, perform
the following procedures:
Remove a PIC Cable
To remove a PIC cable, follow this procedure:
1.
If the PIC connects to fiber-optic cable, have ready a rubber safety cap for each cable you
are removing and the transceiver into which it plugs.
are removing and the transceiver into which it plugs.
2.
Unplug the cable from the cable connector port and immediately place a rubber safety
cap over the port if it connects to fiber-optic cable.
cap over the port if it connects to fiber-optic cable.
3.
Carefully thread the cable through the cable management system, to prevent the cable
from dislodging or developing stress points. Place excess cable out of the way in a neatly
coiled loop in the cable management system. Placing fasteners on the loop helps to
maintain its shape.
from dislodging or developing stress points. Place excess cable out of the way in a neatly
coiled loop in the cable management system. Placing fasteners on the loop helps to
maintain its shape.
Do not look directly into the ends of fiber-optic cables or
the transceivers on the faceplate of a PIC that connects to
fiber-optic cable. Single-mode fiber-optic cable and the
PICs that use it (such as ATM and SONET/SDH) emit laser
light that can damage your eyes.
the transceivers on the faceplate of a PIC that connects to
fiber-optic cable. Single-mode fiber-optic cable and the
PICs that use it (such as ATM and SONET/SDH) emit laser
light that can damage your eyes.
Do not leave a transceiver uncovered except when
removing or inserting the cable. The safety cap keeps the
port clean and prevents accidental exposure to laser light.
removing or inserting the cable. The safety cap keeps the
port clean and prevents accidental exposure to laser light.
Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can
damage the cable and cause problems that are difficult to
diagnose.
radius. An arc smaller than a few inches in diameter can
damage the cable and cause problems that are difficult to
diagnose.
Do not let fiber-optic cable hang free from the connector.
Do not allow fastened loops of cable to dangle, which
stresses the cable at the fastening point.
Do not allow fastened loops of cable to dangle, which
stresses the cable at the fastening point.