Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Replace Cables and Wire Connecting to Routing Engine Interface Ports
M40 Internet Router Hardware Guide
186
Replace Cables and Wire Connecting to Routing Engine Interface Ports
To replace the cables and wires that connect external management devices to the craft
interface (see Figure 88), perform the procedures described in the following sections:
interface (see Figure 88), perform the procedures described in the following sections:
Figure 88: Routing Engine Interface Ports on the Craft Interface
Replace the Management Ethernet Cable
The cable that plugs into the port labeled
MANAGEMENT ETHERNET
on the craft interface
connects the Routing Engine to a network for out-of-band management (see Figure 88). The
port accepts a cable with RJ-45/RJ-45 connectors, which is provided with the router as
detailed in “Routing Engine Interface Cable and Wire Specifications” on page 53.
port accepts a cable with RJ-45/RJ-45 connectors, which is provided with the router as
detailed in “Routing Engine Interface Cable and Wire Specifications” on page 53.
To replace the cable connecting to a management network, follow this procedure:
1.
If a cable is already installed in the
MANAGEMENT ETHERNET
port, perform the following
steps:
a.
Press the tab on the connector and pull the connector straight out of the port.
Figure 89 shows the connector.
Figure 89 shows the connector.
b.
Repeat to disconnect the cable from the network device.
2.
Plug one end of the replacement Ethernet cable into the
MANAGEMENT ETHERNET
port.
3.
Plug the other end of the cable into the network device.
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
0
1
2
3
4
5
6
7
OK
FAIL
MANAGEMENT
ETHERNET
ROUTING ENGINE
CONSOLE
AUXILIARY
OK
MENU
ENTER
ALARM
RED
ALARM
ALARM
ALARM
CUTOFF
NC
C
NO
NC
C
NO
YELLOW
ALARM
ALARM
FAIL
OK
FAIL
OK
1065
Routing Engine ports
Alarm relay contacts