Samsung SRP-275 ユーザーズマニュアル

 

• Memory Switch Setup Mode 
The following items are specified in the Memory Switch setup mode:   
 
Basic Serial communication condition (Serial communication) 

- Transmission speed 
- Parity 
- Handshaking 
- Data length 

Receive buffer full release condition (MSW 8-7) 
Paper roll width (Customize value) 
Cover open status (MSW 8-5) 
 

  NOTES 

All new settings will be lost if the power supply is turned off in the Memory Switch setup mode. Be sure to 

follow the proper procedure, and turn the power off at the correct time. 

 
Use the following procedure to start the Memory Switch setup mode. 
1) Open the rear cover. 
2) Turn the power on while pressing the paper FEED button. 
3) Press the FEED button twice while POWER, ERROR, and PAPER OUT LEDs are lit. 
4) Close the cover. The printer prints the enabled settings of the Memory Switches and instructions. 
5) Follow the instructions to process the switch setup.   
 

  NOTES 

In the Memory Switch setup, the power LED may be flashing.   
 

• Example of Memory Switch setup sheet 

 
Memory S/W Setup 
 
You can choose desired item using 
YES or NO as following 
 
YES: Keep pressing FEED button 
     Until printing starts 
NO : Press & release it swiftly 
 
 
 
Serial interface setting 
 

Do you want to change 
   Serial interface condition? 

 
 
 
 
 
Buffer full release condition 
 
Current condition: 640 bytes left 
 

Do you want to change 
   Buffer full release condition?

 

 

 

 
 
Paper width 
 
Current paper width: 76.0 mm 
 

Do you want to change 
               paper width? 

 
 
 
 
 
Cover open status 
 
Current status: Paper out 
 

Do you want to change 
            cover open status?