Sony cdu-701 ユーザーズマニュアル

12

Installing the Drive Unit into the Computer

Set the jumper

s on the rear of the drive in accor

dance with the

configuration of y

our computer system.

The jumpers are preset at the “MASTER” position as illustrated at
the factor y.

CSEL 

SLAVE 

MASTER 

• Designation of the Drive Number is generally set by inserting a

jumper pin on either the MASTER or the SLAVE pin.

• When the CDU701 is daisy-chained with a Hard Disk Drive on an

IDE Card, set the Hard Disk Drive as MASTER and the CDU701
as SLAVE.

• If the CDU701 is the only device connected to the IDE Card, set

the CDU701 as MASTER.

However , it should be noted that some per

sonal computer

s ma y use

CSEL in lieu of the f

oresaid MASTER/SLA VE selection.  In this

case , remo ve the e xisting jumper

s fr om MASTER and SLA VE, and

set a jumper on CSEL.

 When the CSEL signal of the interface

connector is set lo

w, the drive is designated as Drive 0.

 When the

CSEL is set high,

 the drive is designated as Drive 1.

Consult y our PC man ufacturer , IDE Car d man ufacturer or dealer f

or

further details.