Sony DHC-MD313 ユーザーズマニュアル
9
continued
To listen to analogue components
(except for the optional tape deck
TC-TX313)
(except for the optional tape deck
TC-TX313)
If the sound from a connected component is
distorted, reduce the input level.
distorted, reduce the input level.
1 Press FUNCTION repeatedly until “TAPE”
appears.
2 Turn off the system by pressing POWER.
3 While holding FUNCTION down, press
3 While holding FUNCTION down, press
POWER again.
“Attenuate ON” appears and “ATT”
flashes in the display.
“Attenuate ON” appears and “ATT”
flashes in the display.
To reset to the original level, repeat steps 1, 2,
and 3.
and 3.
LEVEL SYNC
-
ATT
DBFB
A t
n u
t
O N
e
a t e
Connecting optional
A/V components and
outdoor aerials
A/V components and
outdoor aerials
To enhance your system, you can connect
optional components. Refer to the
instructions of each component.
optional components. Refer to the
instructions of each component.
Connecting audio
components
components
Connect the plugs from the optional
component to jacks of the same colour on the
rear panel of this unit.
component to jacks of the same colour on the
rear panel of this unit.
Tip
When you connect the TC-TX313 stereo cassette
deck to the DHC-MD313, be sure to use the AU BUS
terminals.
deck to the DHC-MD313, be sure to use the AU BUS
terminals.
To the audio output of
a tape deck.
a tape deck.
To the audio
input of a
tape deck.
input of a
tape deck.
To the AU BUS connector
of the TC-TX313 stereo
cassette deck.
of the TC-TX313 stereo
cassette deck.
SIGNAL GND