Sony rmo-s591 ユーザーズマニュアル
10
Chapter 2 Getting Started
You can hook up a maximum of seven SCSI
peripheral devices to a single host computer
through its SCSI bus.
Use either of the following Sony SCSI cable
(sold separately) to connect the disk unit.
• MOA-C08 (80 cm, full pitch
peripheral devices to a single host computer
through its SCSI bus.
Use either of the following Sony SCSI cable
(sold separately) to connect the disk unit.
• MOA-C08 (80 cm, full pitch
⇔
full pitch)
Notes:
• Before connecting the disk unit, be sure to turn
• Before connecting the disk unit, be sure to turn
off the disk unit and all other devices on the
SCSI chain.
SCSI chain.
• If the disk unit is the last device on the SCSI
chain, set the function switch F on the rear
panel to “1” to turn on the internal terminator.
When it is not the last device, make sure that the
terminator is off (function switch F is set to
“0”).
panel to “1” to turn on the internal terminator.
When it is not the last device, make sure that the
terminator is off (function switch F is set to
“0”).
• The total length of the SCSI cables connected to
a SCSI chain must not exceed six meters (19
feet 8 1/4 inches).
feet 8 1/4 inches).
Connecting the Disk Unit
A
1
B C D E F G H
0
SCSI CONNECTOR
AC IN
F.GND
SCSI ID
Fig 2-2: Connecting the RMO-S594-DW/S591-DW
to SCSI connector
to AC IN
connector
connector
AC power cord
(supplied)
(supplied)
SCSI cable
(sold separately)
(sold separately)
SCSI cable
(sold separately)
(sold separately)
to another
SCSI device
SCSI device
to the host computer or
another SCSI device
another SCSI device
to an AC outlet
RMO-S594-DW/S591-DW Magneto-Optical Disk Unit