Sony SLV-X9G ユーザーズマニュアル
92
Troubleshooting
T
im
e
r re
co
rd
in
g
The VIDEO Plus+ menu
or the TIMER menu does
not appear.
or the TIMER menu does
not appear.
• Check that TIMER OPTIONS in the OPTIONS-2 menu is
set correctly (see page 84).
The VPS/PDC function
does not operate
properly.
does not operate
properly.
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
Syn
c
hr
o
n
ized R
ecor
d
ing
The SYNCHRO REC
button turns off while
recording or does not go
back to recording
standby mode.
button turns off while
recording or does not go
back to recording
standby mode.
• The tape has reached its end. Insert a new tape and press
SYNCHRO REC again.
The Synchronized
Recording function does
not work.
Recording function does
not work.
• The connected equipment was not turned off.
Turn off the connected equipment and press SYNCHRO
REC again.
REC again.
• There was a power failure. Press SYNCHRO REC again.
The programme recorded
with the Synchronized
Recording function is
incomplete.
with the Synchronized
Recording function is
incomplete.
• If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press SYNCHRO REC again.
Se
t-T
op Bo
x contr
o
l
The Set-Top Box control
function does not work
properly.
function does not work
properly.
• Make sure you are pointing the remote commander only at
the remote sensor on the VCR and not at the STB sensor.
• Make sure you are pointing the STB controller at the
remote sensor on the Set-Top Box.
• Make sure the STB controller is connected securely.
• The STB tuner brand number may be deleted if you
• The STB tuner brand number may be deleted if you
disconnect it from the VCR. Re-enter the brand code
number corresponding to your Set-Top Box (see page 25).
number corresponding to your Set-Top Box (see page 25).
You cannot watch the
STB picture when the
VCR is in standby mode
or recording standby
mode.
STB picture when the
VCR is in standby mode
or recording standby
mode.
• Check that POWER SAVE in the OPTIONS-2 menu is set
to PARTIAL or OFF (see page 84).
Symptom
Remedy