Sony SNCCX600 ユーザーズマニュアル

Ad
minis

tra

ting t

he Camer

a

Configuring the System — System Menu

21

Select how to set the day and time.

Keep current setting: Select if you do not need to set 

the date and time.

Synchronize with PC: Select if you want to 

synchronize the camera’s date and time with the 
computer.

Manual setting: Select if you want to set the camera’s 

date and time manually.
Select the year, month, date, hour, minutes and 
seconds from each drop-down list.

Synchronize with NTP: Select if you want to 

synchronize the camera’s date and time with those of 
the time server called NTP server (Network Time 
Protocol). 
Set the NTP server when Synchronize with NTP is 
selected.

NTP server
Synchronize with the selected NTP server address.

Set the time difference from Greenwich Mean Time in 
the area where the camera is installed.
Select the time zone in the area where the camera is 
installed from the drop-down list.

Automatically adjust clock for daylight saving 
time changes
When selected, the clock is automatically adjusted 
according to the daylight saving time of the selected 
time zone.

If the time zone selected in Time zone is different from 
that set on the computer, the time is adjusted using the 
time zone difference and set on the camera.

You can perform settings related to installation. After 
performing settings, the camera will be restarted.

Set the stabilizer function. Select the checkbox to 
display steadier images when the camera is installed in 
a place subject to vibration.

• When the stabilizer function is set, the angle of image 

taken will be smaller than usual.

• The stabilizer may not respond, depending on the 

amount of vibration.

• Be sure to set this function during the installation.
• Set the privacy masking position or the motion 

detection area, before setting the stabilizer.

See “Buttons common to every menu” on page 19.

Used when rebooting the system.
Click Reboot, and the message “This System will be 
rebooted. Are you sure?” appears. Click OK to reboot 
the camera. It takes about two minutes to restart.

Resets the camera to the factory settings.

Retain current network settings
When this item is checked, only the current network 
settings will be retained after reset.
Click Factory default, and the message “This System 
will be rebooted. Are you sure?” appears. 
When you click OK, the network indicator on the 
camera starts to blink. After adjustments of the default 
settings have finished, the camera reboots automatically. 
Do not turn off the camera until the camera reboots.

The camera can also be reset to the factory settings by 
turning on the power of this unit while pressing the reset 
button on the camera. For details, refer to the supplied 
Installation Manual.

You can format a memory card (not supplied) inserted 
into the card slot of the camera. When you click 
Format, a confirming message appears. Click OK to 
start formatting. Any files and folders stored in the 
memory card will be deleted.

• Before formatting, set Edge Storage movie and Edge 

Storage still image in the Execution Condition tab of 
the Action output menu to Off, to write-protect the 
memory card.

• Do not activate the Format memory card function 

when no card is inserted into the card slot.