Sony STR-DH510 ユーザーズマニュアル
39
GB
T
u
n
e
r Op
era
tio
ns
You can enter the frequency of a station
directly by using the numeric buttons.
directly by using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
the receiver.
2
Press D.TUNING.
3
Press and hold SHIFT, then
press the numeric buttons to
enter the frequency.
press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
• Models of area code U2 and CA2:
• Models of area code U2 and CA2:
Select 1
b 0 b 2 b 5
• Models of area code ECE, CEK and
AU1:
Select 1
b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1
Select 1
b 3 b 5 b 0
4
Press and hold SHIFT, then
press ENTER.
press ENTER.
You can also use MEMORY/ENTER on
the receiver.
the receiver.
Tip
If you have tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
direction of the AM loop antenna for optimum
reception.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
(Models of area code U2, CA2 only)
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
receiver.
9 kHz or 10 kHz using the buttons on the
receiver.
1
Press ?/1 to turn off the
receiver.
receiver.
2
While holding down TUNING
MODE, press ?/1.
MODE, press ?/1.
3
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
the tuning scale.
Tuning into a station directly
(Direct Tuning)
(Direct Tuning)
Changing the AM tuning scale
?/1
?/1
TUNING MODE