Sony STR-DH810 ユーザーズマニュアル
40
GB
*
xxx
represent a speaker channel
FL
Front left
FR
Front right
CNT
Center
SL
Surround left
SR
Surround right
SBL
Surround back left
SBR
Surround back right
LH
Front left high
RH
Front right high
SW
Subwoofer
Depending on the measurement result, the speaker
channel may not appears.
channel may not appears.
To return to step 2 of
“3: Confirming/saving the
measurement results”
measurement results”
Press .
Tip
Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
You can use the AUTO CAL menu to make
various adjustments for Auto Calibration
settings and to name the position.
For details on adjusting the parameters, see
“Using the setting menu” (page 72).
various adjustments for Auto Calibration
settings and to name the position.
For details on adjusting the parameters, see
“Using the setting menu” (page 72).
x A.CAL START
x CAL TYPE*
Lets you select the Auto Calibration type for
each seating position. For details, see step 4 of
“3: Confirming/saving the measurement
results” (page 38).
each seating position. For details, see step 4 of
“3: Confirming/saving the measurement
results” (page 38).
* You can select this parameter only when you have
performed the Auto Calibration and saved the
settings.
settings.
x POSITION
You can register three patterns as position 1, 2
and 3, depending on the seating positions,
listening environment, and measurement
conditions.
If you do not select the position number, the
Auto Calibration result will automatically save
as POS 1 (initial setting).
and 3, depending on the seating positions,
listening environment, and measurement
conditions.
If you do not select the position number, the
Auto Calibration result will automatically save
as POS 1 (initial setting).
To register settings for the
listening environment
listening environment
You can select the seating position you want
and register the measurement results of the
Auto Calibration for that seating position.
and register the measurement results of the
Auto Calibration for that seating position.
1
Press AMP MENU.
2
Press
V/v repeatedly to select “<AUTO
CAL>”, then press
or
b.
3
Press
V/v repeatedly to select
“POSITION”, then press
or
b.
4
Press
V/v repeatedly to select the
position (POS 1, 2, 3) for which you
want to register the measurement
results, then press
want to register the measurement
results, then press
.
W -
xxx
*
: 42
The volume of the receiver is out of the acceptable
range. Try to perform the measurement when the
environment is quiet enough to allow proper
measurement.
range. Try to perform the measurement when the
environment is quiet enough to allow proper
measurement.
W -
xxx
*
: 43
The distance and position of a subwoofer cannot be
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
NO WARN
There is no warning information.
There is no warning information.
Display and explanation
AUTO CAL menu