Nokia 112T ユーザーズマニュアル
GB 9
Connecting the Mediamaster & First-time installation
• Some outdoor aerials are directed towards an analogue
transmitter. The aerial must be directed towards a digital TV
transmitter.
transmitter.
• It is not always advisable to position the aerial as high as
possible. If problems arise, experiment with different aerial
heights.
heights.
2. Indoor and window-mounted aerials
This type of aerial may be enough if the reception conditions are
very good. When an indoor aerial is used, please note the following:
very good. When an indoor aerial is used, please note the following:
• Use an aerial for UHF/VHF channels (21-69), e.g. a directional
aerial.
• Place the aerial by the window and direct it towards the TV
transmitter, if possible.
• It is recommended that you use a Nokia active aerial with a
built-in amplifier to provide a stronger signal.
The strength of the TV signal varies according to reflections from,
for example, buildings. The signal penetrates thick stone or
concrete walls poorly. A wooden building, however, is not an
insurmountable barrier for digital TV signals.
for example, buildings. The signal penetrates thick stone or
concrete walls poorly. A wooden building, however, is not an
insurmountable barrier for digital TV signals.
The 5 V power for the active antenna
The Nokia active indoor antenna must be powered with 5 V from
the TV aerial connector on the rear of the Mediamaster.
the TV aerial connector on the rear of the Mediamaster.
If your Mediamaster is connected to a local antenna system, e.g. in
a rented flat, the 5 V power might disturb the antenna system in the
building when it is switched ON. You can switch OFF the 5 V from the
TV menu.
a rented flat, the 5 V power might disturb the antenna system in the
building when it is switched ON. You can switch OFF the 5 V from the
TV menu.
First-time installation general information
Once you have correctly connected the Mediamaster, you will also
have to perform a "First-time installation." During this procedure,
helpful information is displayed at the bottom of the menus.
have to perform a "First-time installation." During this procedure,
helpful information is displayed at the bottom of the menus.
The ok button always confirms a selection within these menus,
and pressing it will take you to the next step in the installation
process. However, sometimes more than one value has to be
entered in a menu. Make all the necessary changes first.
Then, confirm them all simultaneously by pressing ok.
and pressing it will take you to the next step in the installation
process. However, sometimes more than one value has to be
entered in a menu. Make all the necessary changes first.
Then, confirm them all simultaneously by pressing ok.
• You can always go back to the previous menu by pressing back.
• Use the cursor up/down buttons
to move upwards and
downwards from one line to another.
• Use the cursor left/right buttons
to change settings.
• Use the number buttons on the remote control to enter numeric
values.