Nokia 3220 サービスマニュアル

Nokia Custome Care

Service Sofftware and Tuning Instructions

RH-37

Issue 1 07/04

Nokia Corporation

Page 43

If the UEMEK or the Combo memory has been changed, the baseband has to be cali-
brated. It is only the UEMEK that has to be calibrated for baseband.

•

Connect the phone to a PC, which has Phoenix Service Software and a dongle 
installed. A JBV-1 box and an FPS-8 flash box are also needed.

-  Connect the JBV-1 to a external power supply and adjust the

voltage to 12-15 V and limit the current to 0.5 - 3 A.

-

Connect the JBV-1 with the XCS-4 cable to the FPS-8-box and take
care that the JBV-1 box is properly connected to the PC by the serial
cable.

-  Attach the phone to the JBV-1 properly. 

-

Connect the phone and the JBV-1 box via the SCB-3 cable.

• Start Phoenix Service Software and open FBUS connection.

• Select <Scan Product> (Ctrl-R or in menu file < Scan Product>). 

• Wait until the phone information is shown in the lower right corner of the 

screen.

• Set the operating mode to <Local>.

Select “Tuning” and “Energy Management Calibration” in Phoenix menu.