Nokia A032 ユーザーズマニュアル
© NOKIA INC | File: a032trbsv2.doc | Date: 15.08.01
INTERNET
8/11
You should now be able to access the network via the A032 from your wireless station machine.
3.
RESETTING FACTORY DEFAULTS
If you don’t know the Nokia A032’s current configuration status and you want to ensure that you are
starting from a clean and known state, you can restore the factory default settings.
starting from a clean and known state, you can restore the factory default settings.
You might want to do this before using Learn mode to configure the Nokia A032.
Assuming the Nokia A032 is not security locked (see the Nokia A032 Wireless LAN Access Point User
Guide) you can use the following procedure:
Guide) you can use the following procedure:
1. Put the Nokia A032 into Learn mode
2. Hold in the mode button.
The LED’s perform a binary count, slowly coming on from left to right.
3. Keep holding the mode button until all the LED’s are on. This takes about 10 seconds.
The unit has now overwritten the configuration with the factory defaults, and it should restart.
Remember to hold the mode button again when the unit restarts if you want to return to Learn mode.
4. GENERAL
ACCESS
POINT
TROUBLESHOOTING
4.1 WEB MANAGEMENT CHANGES
If the web management screen is not updating changes after information is entered the most likely
cause is forgetting to press Enter before pressing Save.
cause is forgetting to press Enter before pressing Save.
Enter the required values and press Enter. Then press Save.
You may make changes on one Web Management page, press Enter and then update values on other
Web Management screen (remembering to press Enter before moving to the next page) and then
press Save to update all the changes. If you forgot to press Enter (and just press save) the changes
on that specific page will be lost.
Web Management screen (remembering to press Enter before moving to the next page) and then
press Save to update all the changes. If you forgot to press Enter (and just press save) the changes
on that specific page will be lost.
4.2 INTERNET ACCESS WITH FIXED IP ADDRESSES
If the Access Point is not configured as a DHCP server and wireless station is not forcing a dial out
when it is connected to a modem, it is likely that the gateway on the wireless station is not set up
correctly. The IP Address of the Access Point must be configured as a gateway in the wireless station.
when it is connected to a modem, it is likely that the gateway on the wireless station is not set up
correctly. The IP Address of the Access Point must be configured as a gateway in the wireless station.
1. Right click the mouse on Network Neighborhood icon on the desktop.
2. Choose
Properties
3. Highlight TCP/IP -> Nokia C11x Wireless LAN Card and Click Properties
4. Click
Gateway tab and enter IP address of Access Point.
5. Click
OK and restart the wireless station.