Panasonic cq-drx900n ユーザーズマニュアル

53 mm

182 mm

The unit can be installed in any dash-
board having an opening as shown at 
right.  The dashboard should be 4.5 mm 
- 6 mm thick in order to be able to support the unit.

This product should be installed by a professional installer, if 
possible.
In case of difficulty, please consult your nearest authorized 
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery system 

(car) with negative ground.

2. Follow the electrical connections carefully.

Failure to do so may result in damage to the unit.

3. Connect the power lead after all other connections are made.
4. Be sure to connect the battery lead (yellow) to the positive ter-

minal (+) of the battery or fuse block (BAT) terminal.

5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions 

of the respective equipment before connecting it to this unit.

¡

Before installation, check the radio operation with antenna and 
speakers.

¡

Disconnect the cable from the negative (-) battery terminal 
(see caution below).

¡

Unit should be installed in a horizontal position with the front 
end up at a convenient angle, but not more than 30

°

.

 :  Do not disconnect the battery terminals of a car 

with trip or navigational computer since all user settings 
stored in memory will be lost.  Instead take extra care with 
installing the unit to prevent shorts.

¡

We strongly recommend that you wear gloves for 
installation work to protect yourself from injuries.

First complete the electrical connections, and then 
check them for correctness.

less than 30

°

Lock Lever (C)

Power Connector e

38