HP Compaq KB-9965 311059-131 ユーザーズマニュアル

8.  Press the latch adjacent to the system tray release handle to release the system tray (1). 

9.  Grasp the system tray release handle and pull the tray from the chassis until it stops in the 

extended position (2). 

10.  Disconnect all internal cables connected to the system tray. For cable routing 

information, refer to “Cable Routing Diagrams” in this chapter. 

 

 

  Do not pull the system tray completely out from the server unless all cables 

have been disconnected. 

11.  Push and hold the latches on either side of the system tray (3). 

12.  Slide the system tray out from the chassis (4). 

 

13.  Place the system tray on a level nonconductive surface. 

14.  Be sure that the system switch settings on the system tray you are installing match those 

on the system tray you are removing. Refer to “System Board Switches” in Chapter 4 
“Connectors, LEDs, and Switches.” 

15.  Transfer all memory boards, expansion boards, PPMs, and processors onto the new 

system board. Refer to the appropriate sections in this chapter regarding the removal of 
these components. 

 

  Be sure that all components occupy the same locations in the new tray as they did 

on the failed one. Failure to configure the new board exactly like the failed one may result in data 

loss. 

Reverse steps 1 through 12 to replace the system tray. 

 

  The server serial number must be re-entered through RBSU after replacing the system 

tray. Refer to “Re-entering the Server Serial Number” in this chapter.