Panasonic PT-D3500U ユーザーズマニュアル
Using the REMOTE 2 terminal
41
Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
Pin assignments and control
Be sure to short-circuit Pins
and
when controlling.
D-Sub 9-pin (female)
external appearance
external appearance
• The following buttons on the remote control and the operation area of the projector can no longer
be operated when pins
and
are shorted: POWER button and SHUTTER button.
Neither will it be possible to use the RS232C commands or network functions corresponding to
these functions.
these functions.
• If you short pin
and pin
, and also short one of the pins from
to
and pin
, then the
following buttons on the projector operating area and the remote control can no longer be
operated: POWER button, RGB button (RGB1, RGB2 and DVI buttons in case of remote control),
VIDEO button (VIDEO and S-VIDEO buttons in case of remote control) and SHUTTER button.
operated: POWER button, RGB button (RGB1, RGB2 and DVI buttons in case of remote control),
VIDEO button (VIDEO and S-VIDEO buttons in case of remote control) and SHUTTER button.
Neither will it be possible to use the RS232C commands or network functions corresponding to
these functions.
these functions.
Note
;;;
DVI
Example of a control panel layout
Projector set up in a meeting room
Control panel located in a different room
STANDBY
ON
LAMP
Remote terminal
External control
Remote terminal/External control
RGB1
VIDEO
RGB2
S-VIDEO
Names of terminals
GND
POWER
RGB1
RGB2
VIDEO
S-VIDEO
DVI
SHUTTER
RST / SET
Open (H)
Controlled by remote control
OFF
Other
OFF
Short (L)
Controlled by external contact
ON
DVI
S-VIDEO
VIDEO
RGB2
RGB1
ON
GND
Other
Other
Other
Other