Hitachi VM-E520A ユーザーズマニュアル
Getting Started
- 14 -
Before you install the battery for the first time it must be fully charged. Refer to "Charging the Battery" on page 12
for details.
for details.
1. Lift the OPEN lever and pull it up. The power supply attachment cover will open.
2. With the battery compartment facing you, align arrow on the battery with the arrow on the camcorder.
3. Once the arrows are aligned, push down on the battery.
4. While pushing down the battery, slide it to the right until it "clicks" into place.
5. After installing the battery, close the cover. Hold the OPEN lever and align the tabs on both sides of the cover
with the end of the attachment section.
with the end of the attachment section.
Note: If the OPEN lever is flat, the cover will not close.
Note: Always remove the battery from the camcorder after use.
Note: We cannot guarantee against malfunctions of the camcorder which occur when you use battery packs
other than those specified.
Note: Always attach a battery by the procedure described here. Attaching a battery forcibly could damage it.
Note: Always remove the battery from the camcorder after use.
Note: We cannot guarantee against malfunctions of the camcorder which occur when you use battery packs
other than those specified.
Note: Always attach a battery by the procedure described here. Attaching a battery forcibly could damage it.