JVC 0105kth-mw-bj ユーザーズマニュアル
Filename [XV38ASAG_057S-VHS.fm]
Masterpage:Left+
24
EN
Page 24
December 14, 2004 8:12 pm
OPERATIONS ON VHS DECK (cont.)
Recording Features
Record One Programme While
Watching Another
Watching Another
Once recording is in progress, all you need to do is to set
the channel controls on the TV for the station you wish to
view.
the channel controls on the TV for the station you wish to
view.
● The programme selected with the TV’s channel controls
appears on the TV screen, while the one selected with the
unit’s PR buttons is recorded on the tape.
unit’s PR buttons is recorded on the tape.
NOTE:
You can also use the DVD deck in the following cases. Before
use, be sure to turn on the unit and select the DVD deck.
use, be sure to turn on the unit and select the DVD deck.
● During recording
● During timer recording
● During timer standby mode
Instant Timer Recording (ITR)
This easy method lets you record for
from 30 minutes to 6 hours (selectable in
30-min. increments), and shuts the unit
off after recording is finished.
from 30 minutes to 6 hours (selectable in
30-min. increments), and shuts the unit
off after recording is finished.
1
Start recording.
Press 7 on the unit.
2
Engage the ITR mode.
Press 7 again. “
䡬
” blinks and “0:30” appears on the
front display panel.
3
Set the recording duration.
If you want to record for more than 30 minutes, press 7
to extend the time. Each press extends recording time by
30 minutes.
to extend the time. Each press extends recording time by
30 minutes.
NOTES:
● You can only perform ITR using the 7 button on the unit’s
front panel.
● When the end of the tape is reached during Instant Timer
Recording, the unit is turned off and “
䡬
” and “$” blink on
the front display panel.
● When the end of the tape is reached during timer recording,
the unit is turned off and “
7
”, “
4
” and “
#
” blink on the front
display panel.
Elapsed Recording Time Indication
1
Set the counter display.
Press – –:– – until a counter reading appears on the front
display panel.
display panel.
2
Reset the counter.
Press 0000 before starting recording or playback.
● The counter is reset to “0:00:00” and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
recording or playback.
Tape Remaining Time
Press – –:– – until the time remaining on the tape
appears.
appears.
● The front display panel shows the tape remaining time with “:”
displayed.
● By pressing the – –:– – button, you can change the display to
show the channel position, clock time, counter reading, and
tape remaining time.
tape remaining time.
* The channel position is not displayed during playback.
NOTES:
● When you press – –:– –, the on-screen display appears on the
TV screen for 5 seconds.
● Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
“– –:– –” may sometimes appear with “:” blinking, or the
display may blink on occasion.
“– –:– –” may sometimes appear with “:” blinking, or the
display may blink on occasion.
● Turn on the TV and select the video channel (or AV
mode).
● Slide the TV/VCR/DVD switch on the remote
control to the right.
Slide to the
right.
right.
XV38ASAG_057S-VHS.fm Page 24 Tuesday, December 14, 2004 8:12 PM