JVC CA-MXJE3 ユーザーズマニュアル
5
⁄
Front speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: (+) to (+) and (–) to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• The speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s
may cause color distortions. So, pay attention to the
following when installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
speakers.
Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have
followed the above. If this happens, move the speakers away
from the TV.
followed the above. If this happens, move the speakers away
from the TV.
@
Voltage Selector
Use a screwdriver to rotate the voltage selector so that the
voltage mark is pointing at the same voltage as where you
are plugging in the unit. (See also the back cover page.)
voltage mark is pointing at the same voltage as where you
are plugging in the unit. (See also the back cover page.)
Preparing the Remote Control
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
of the speakers.
CAUTION:
SPEAKERS IMPEDANCE
6
Ω –16Ω
SPEAKERS
From right front main
speaker
speaker
From left front main
speaker
speaker
DO NOT plug in before setting the voltage
selector on the rear of the unit and all
connection procedures are complete.
selector on the rear of the unit and all
connection procedures are complete.
DO NOT recharge, short, disassemble or
heat the battery or dispose of it in a fire.
heat the battery or dispose of it in a fire.
Voltage mark
Voltage mark
When your mains lead (AC)
line voltage is 220 V
line voltage is 220 V
When your mains lead (AC)
line voltage is 230-240 V
line voltage is 230-240 V
Voltage mark
Voltage mark
When your mains lead (AC)
line voltage is 127 V
line voltage is 127 V
When your mains lead (AC)
line voltage is 110 V
line voltage is 110 V
R6(SUM-3)/AA(15F)
MX-JE3.book Page 5 Thursday,January13, 2005 3:32 PM