JVC DX-T55 ユーザーズマニュアル

@

 

• When connecting the speaker cords, match their polarity 

with that of the speaker terminals: red/white to (+) and black 
to (–).

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the System.

• The front main speakers are magnetically shielded to avoid 

color distortions on TVs. However, if not installed properly, 
it may cause color distortions. So, pay attention to the 
following when installing the speakers.
– When placing the speakers near a TV set, turn off the 

TV’s main power switch or unplug it before installing the 
speakers.
Then wait at least 30 minutes before turning on the TV’s 
main power switch again.

Some TVs may still be affected even though you have 
followed the above instruction. If this happens, move the 
speakers away from the TV.

¤

#

 

• Dispose of batteries in the proper manner, according to 

federal, state, and local regulations.

• DO NOT connect more than one speaker to 

each terminal.

• DO NOT push or pull the speakers as this 

will damage the foot spacers at the bottom 
of the speakers.

1

2

3

4

From right front main 
speaker

From left front 
main speaker

From left matrix 
surround speaker

From right matrix 
surround speaker

 

Use a screwdriver to rotate the 
voltage selector so that the voltage 
mark is pointing to the same voltage 
as where you are plugging in the unit. 
(See also the back cover page.)

DO NOT plug in before setting the voltage 
selector and all connection procedures are 
completed.

 

 point the top of the 

remote control toward the 
remote sensor as directly as 
possible. If you operate it 
from a diagonal position, 
the operating range (approx. 
5 m) may be shorter.

DO NOT recharge, short, disassemble, heat 
the battery or dispose of it in a fire.

Holes

Speaker grille

Projection

From the powered subwoofer
(not supplied)

Voltage mark

R6(SUM-3)/AA(15F)

DXT55_UW.book Page 5 Tuesday, May 9, 2006 1:08 PM