JVC dr-m70sek ユーザーズマニュアル

28

EN

®

You can programme the timer using the PlusCode 
numbers that are printed in your local TV guide 
magazine.

• If the Timer Programming list is full, the Timer 

Programming mode is activated instead of the 
VIDEO Plus+ programming mode.

• Press [the VIDEO Plus+ button] again in the 

VIDEO Plus+ programming mode to switch to 
the Timer Programming mode.

U / D], then press 

Once: To record a TV programme once, as you 
set.
Daily: To record a TV programme at the same 
time on the same channel everyday.
M-F: To record a TV programme at the same time 
on the same channel from Monday through 
Friday.
Weekly: To record a TV programme at the same 
time on the same channel every week.

U / D], then press 

P].

• If your local channel information is programmed 

in the unit’s memory, your local channel number 
appears automatically. 

• If your local channel information is not 

programmed in the unit’s memory, “P– –” may 
appear. 

• If you select the channel number using 

[Cursor 

U / D], it is stored in the unit’s 

memory.

U / D], then press 

P].

Press [STANDBY/ON y/I].

The 

 icon will appear on the front panel display 

and the unit enters to the timer-standby mode.

• If you have not set the clock, the clock setting 

window will appear after step 1. Continue from step 
5 in “Clock Setting” before programming the timer. 
(See page 19.)

• If the PlusCode number is not available, “Code 

Error” is displayed and the number will clear when 
you press [ENTER] in step 2.

• If the PlusCode number previously set overlaps with 

the one you entered and the channel is different, 
“Overlap” is displayed but the timer programming 
will be cleared when you press [ENTER] in step 3.

• If you enter the same PlusCode number and the 

recording pattern which you have already entered, 
the previously set programme will be overwritten.

• If you enter the same PlusCode number but a 

different recording pattern, it will be saved as a new 
programme and added to the timer programming 
list.

“Code Error” is displayed if:
• A past time is entered for start and end times.
• The PlusCode number cannot be decoded.

“Overlap” is displayed if:
• There is an overlap with a timer recording 

setting in different channels.

E6851BD_EN.book  Page 28  Tuesday, August 2, 2005  5:57 PM