JVC GR-DF565 ユーザーズマニュアル

MasterPage: Start_Right

The audio track can be customised only when 
recorded in the 12-BIT and SP modes. 
(

● Use the provided remote control. 

Play back the tape to locate the point where 

editing will start, then press PAUSE (9).

While holding A. DUB (D) on the remote 

control, press PAUSE (9). The “9D” and “MIC” 
indicators appear.

Press PLAY (U), then begin “narrating”. 

Speak into the microphone.

● To pause dubbing, press PAUSE (9).

To end Audio Dubbing, press PAUSE (9), 

then STOP (8).

To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”. 
(

墌 pg. 37, 41)

● Sound is not heard from the speaker during Audio 

Dubbing.

● When editing onto a tape that was recorded at 

12-BIT, the old and new soundtracks are recorded 
separately.

● If you dub onto a blank space on the tape, the 

sound may be disrupted. Make sure you only edit 
recorded areas.

● If feedback or howling occurs during TV playback, 

move the camcorder’s microphone away from the 
TV, or turn down the TV’s volume.

● If you change from 12-BIT to 16-BIT in mid-

recording and then use the tape for Audio 
Dubbing, it is not effective from the point where 
16-BIT recording began.

● During Audio Dubbing, when the tape moves to 

scenes recorded in the LP mode, scenes 
recorded in 16-BIT audio or a blank portion, Audio 
Dubbing stops.

● Audio dubbing is also possible using an optional 

microphone connected to the MIC connector.

● While an optional microphone is connected, the 

built-in microphone is disabled. 

GR-DF565PAL.book  Page 55  Thursday, January 27, 2005  12:30 PM