JVC kd-nx901 ユーザーズマニュアル
11
ENGLISH
Preparations
1
Turn on the ignition switch (either to
ON or to ACC).
2
Press
to turn on the power, then
press NAVI/AV.
3
Select your preferred language and set
your measured angle.
• When shipped from the factory, navigation
language is set to UK English.
• See “Measuring the installation angle” on
the Installation/Connection Manual (and also
pages 20 and 21).
pages 20 and 21).
4
Confirm the following connections on
the screen.
GPS antenna A:
• GPS:OK
\ Connection is OK.
• GPS:NG
\ Antenna is disconnected or short-
circuited.
Parking brake lead B:
Step on the brake pedal, then disengage and
engage the parking brake repeatedly.
engage the parking brake repeatedly.
• If “PKG:OFF” appears when disengaged
and “PKG:ON” appears when engaged,
connection is OK.
connection is OK.
Reversing signal lead C:
Engage the parking brake, step on the brake
pedal, then shift the gearchange lever.
pedal, then shift the gearchange lever.
• If “D:FWD/H” and “D:FWD/L” alternate
on the screen, connection is OK. (Only after
calibration is started, “REV” appears when
the gearchange lever is set to reverse.)
calibration is started, “REV” appears when
the gearchange lever is set to reverse.)
Speed signal lead D:
Drive the car for a while.
• If the number increases as you speed up the
Drive the car for a while.
• If the number increases as you speed up the
car, connection is OK.
If connection is not good, check the connection.
Before using the Navigation System first time, it is required to calibrate the Navigation System.
• After deleting the run time (DELETE RUNTIME: see page 21) or changing the installation angle
• After deleting the run time (DELETE RUNTIME: see page 21) or changing the installation angle
(UNIT ANGLE: see page 21), calibration is also required.
1
2
3
4
A
B
C
D
To be continued....
EN11-29_KD-NX901[E]NAVIfb.indd 11
EN11-29_KD-NX901[E]NAVIfb.indd 11
05.3.17 2:00:39 PM
05.3.17 2:00:39 PM